brennenstuhl SOL ML 1000 Manuel Utilisateur page 8

064520 BA_TwinsPad.qxp
D
User Manual
INSTALLATION B: PUT ON FLAT SURFACE DIRECTLY
Push aside the stand bracket and put it on a flat surface.
INSTALLATION C: HANG ON THE WALL
① Please drill 2 holes of Φ8mm on the wall with a spacing of 88.5mm.
② Fix the expansion plugs and screws into the holes with a spare space(do not lock to the bottom).
③ Push aside the stand bracket, align the hanging holes to the screws and hang the lamp on the
wall.
* The recommended hanging height is less than 2Mtrs.
1
NOTICE & WARNING
1. This is a solar powered lamp, please install it in a location where can get enough sunshine.
2. Please note the lighting time depends on sunshine duration & weather.
3. Built-in intelligent IC is with over-charge,over-discharge and over-voltage protection.
4. The lamp is equipped with an internal battery pack, which is replaceable. If any need, please
contact seller for correct new battery pack.
5. If the battery is taken out and put back in or replaced with new ones, please toward the solar
panel to sunshine or a strong light to activate the lamp.
6. Non-professionals please de not disassemble the lamp.
7. Please do not dispose the battery with household garbage to avoid explosion.
8
22.12.20 12:18 Seite 8
3
2