Operating Instructions; Using Osd Controller; Description Of The Osd Control Operation; Description Of The Motorized Zoom&Focus Adjustment - Eneo MPD-64A0003P0A Guide D'installation Rapide

Operating instructions

Using OSD controller

Setup menu can be accessed and controlled by OSD control joy stick on the side of the
gimbal. Five commands are available with the joystick.
HD-SDI or EX-SDI is selectable by Video format switch only. TVI mode or AHD mode is
i
selectable in the menu only. (SYSTEM> ANALOG MODE)

Description of the OSD control operation

1. SET Key (●) : Access to the menu or enter the setting. To enter the main menu,
press the Set Key down.
2. UP/DOWN Key (▲/▼) : Choose the desired sub-menu and to move the cursor up or
down.
3. LEFT/RIGHT Key (◄/►) : Set up the value of the selected menu. Used to adjust the
desired menu selection and to move the cursor left or right.
4. '☟' denotes the long press down straightly for about 2 seconds
Description of the Motorized ZOOM&FOCUS adjustment
Works only when OSD Menu is inactive.
i
1. ▲ : Zoom In
2. ▼ : Zoom Out
3. ◄ : Focus Near
4. ► : Focus Far
EX-SDI <-> HD-SDI
Video Format DIP Switch
OSD control Joystick
Video Sub-out connector
EN
11