Operating Instructions; Power Supply Connections; Using Osd Controller; Description Of The Osd Control Operation - Eneo MPC-54A0003M0A Guide Rapide

Operating instructions

Power Supply connections

Camera can work with either 24VAC or 12VDC, dual voltage power. Primary and second-
ary grounds are completely isolated to avoid the possible ground-loop problems.

Using OSD controller

Setup menu can be accessed and controlled by OSD control joystick on the rear of the
camera unit. Five commands are available with the joystick.
i
HD-SDI or EX-SDI is selectable by Video format switch only. TVI mode or AHD mode is
selectable in the menu only. (SYSTEM> ANALOG MODE)

Description of the OSD control operation

1. SET Key (●) : Access to the menu or enter the setting. To enter the main menu,
press the Set Key down.
2. UP/DOWN Key (▲/▼) : Choose the desired sub-menu and to move the cursor up or
down.
3. LEFT/RIGHT Key (◄/►) : Set up the value of the selected menu. Used to adjust the
desired menu selection and to move the cursor left or right.
4. '☟' denotes the long press down straightly for about 2 seconds
Description of the Motorized ZOOM&FOCUS adjustment
i
Works only when OSD Menu is inactive.
1. ▲ : Zoom In
2. ▼ : Zoom Out
3. ◄ : Focus Near
4. ► : Focus Far
8
OSD Control Joy Stick
Video format Switch