Use; User Panel Functions - Vortice VORT HRI PHANTOM Livret D'instructions

ENGLISH

Use

In B.P. models, when the appliance is switched on and has been running for 2 minutes, both motors will stop to allow
repositioning of the bypass valve. The motors will start up again after approximately 1 minutes.
N.B. This is a normal system procedure and should not be perceived as a malfunction.
The appliance is wired to a special dedicated control panel, the functions of which are described further on.
This model can be used in combination with a Vortice preheater, which must be fitted and set up by the installer.
The minimum distance of the preheater from the appliance is 500 mm.

User panel functions

General (fig.10)
A = "UP" button: list up
B = "DOWN" button: list down
C = SET button: acquire data
D = ESC button: exit
E = display
This model comes with a panel which offers the user control of
the parameters:
- on/off
- current time/day
- operating speed
- required room temperature
- selection of bypass function
The function of the ESC button, unless otherwise stated, is always that of quitting without saving data.
Summary of icons displayed on the panel (Fig.11)
11 11
8 9
14
16 17 18
1 2 3
11 time profile P2: (see "User Menu").
12 HA
13 --
14 current fan speed: with the appliance in operation, the icons light up steadily to indicate which of the 3 speeds is
currently selected.
15 system standby status: the icon lights up permanently when the appliance is in standby (powered up, but with the
motors at a standstill); the icon will flash to indicate that the appliance has reverted to standby after being programmed
(see "Program time profiles"); if the icon lights up and is accompanied by the message "OFF" on the right of the
display, this means that the appliance has been switched off remotely (when connected to a home automation
system).
16 the icon flashes to indicate that an alarm condition has been triggered; this indicates that an alarm with no manual
reset has been tripped (see "View alarms menu") .
10 11 12 13
15
19
20
4 5 6 7
10 10
FILT
E
D
1-7 day of the week: 1=Monday, 2=Tuesday, etc.
8 filter alarm: this icon lights up to warn that the filters should
be replaced within two months; if the filters are not renewed
by the end of this period, the filter error message Filt appears
(see "View alarm menu").
9 no-frost function: the icon lights up permanently when the
no-frost procedure is active; the icon will flash to indicate a
"no-frost timeout": in this instance the no-frost procedure has
proved insufficient and the appliance goes into protected
mode for one hour, with the motors stopped, following which
the system will restart the machine.
10 time profile P1: (see "User menu").
P1 P2
P1/P2
1 2 3 4 5 6 7
esc set
Prg
/ °C
By-Pass
C
A
B
19