M-system MFTW120IX Notice Pour L'installation, L'utilisation Et L'entretien page 83

LOCATION AND AERATION
Gas cookers must always discharge combustion
products and moisture through hoods connected to
flues or directly to the outside (fig. 15).
If it is impossible to use a hood, a fan should be
installed in a window or on an external wall. The fan
should be switched on each time the appliance is used
(fig. 15) and must comply with all relevant standards
regarding ventilation
AIR INLET MIN. SECT. 100 cm
AIR INLET MIN. SECT. 100 cm
AIR INLET MIN. SECT. 100 cm
INSTRUCTIONS FOR THE INSTALLER
13
2
14
2
15
2
POSITIONING THE COOKER
The appliances are fitted with the following parts to
enable them to be correctly positioned:
• Adjustable feet, to be fitted to the appliance, which
allow the height of the cooker to be aligned with
other kitchen furniture (fig.16 and 16a).
• Backguard (A). The cookers which are equipped
with this accessory, leave of the factory with this
particular inserted inside the packing. In order to
install the backguard, it is necessary to loosen the
screws (V) positioned on the back of the hob and
then to fix the backgaurd as indicated in figure 17
A
22
16
1 6 a
V
17