Instructions For The Installer - M-system MFTW120IX Notice Pour L'installation, L'utilisation Et L'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TECHNICAL INFORMATION
• The installation, adjustments, conversions and
maintenance operations listed in this part must
only be carried out by qualified personnel. The
manufacturer cannot be held responsible for any
damage to persons or property resulting from an
incorrect installation of the appliance.
• The safety and automatic adjustment devices of the
appliances may, during its life, only be modified by
the manufacturer or duly authorised supplier.
• In accordance with the gas standard, the all-gas
and combi appliances are "class 1" (free standing)
or "class 2 subclass 1" (recessed) and, as such,
must comply with the clearances specified in
fig.H.consequently any side walls must be no higher
than the work top.
The appliance is to be placed directly on the floor and
should not be mounted on a base.
• The walls adjacent to and surrounding the appliances
must be able to withstand an temperature of 95 °C.
• The installation of all-gas and combi appliances
must comply with the standards in force.
• This appliance is not connected to a flue for
discharge of the combustion products; therefore, it
must be connected in compliance with the above
mentioned installation rules. Particular attention
must be paid to the instructions given below for
ventilation and aeration.
INSTALLATION
UNPACKING YOUR COOKER
• Once the wrapping has been removed from the outer
surfaces and the various inner parts, thoroughly
check that the appliance is in perfect condition. If
you have any doubts do not use the appliance and
call in a qualified person.
• Some parts mounted on the appliance are protected
by a plastic film. This protection must be removed
before using the appliance. We recommend slitting
the plastic film along the edges with a sharp knife or
pin.
• Do not move the appliance by the handle.
The packaging materials used (cardboard, bags,
polystyrene foam, nails etc.) must not be left
anywhere within easy reach of children as they
are a potential hazard source.

INSTRUCTIONS FOR THE INSTALLER

50 mm
VENTILATION
The room where the appliance is installed should be
no less than 20 m³.
The quantity of air necessary is that required for a
regular combustion of the gas and for the ventilation of
the room. The natural flow of air must be direct through
permanent apertures in the walls of the room that open
directly to the outside with a minimum cross section of
100 cm
(fig. 15). These apertures must be positioned
2
in such a way as not to be obstructed.
Indirect ventilation is also allowed by taking air from
adjacent rooms to the one to be ventilated, and must
comply with all current standards.
21
GB
H

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mftw120ixbMftw120ixbe

Table des Matières