Troubleshooting Tips; Trouble Shooting - Airwell MFH Serie Manuel D'utilisation Et D'installation

TROUBLESHOOTING TIPS

TROUBLE SHOOTING

TROUBLES
1. Unit does not
Start when
Pressing on/off
Button
2. Not cool enough
4. Noisy or vibration
5. Gurgling sound
6. Power shut off at
Heating mode
POSSIBLE CAUSES
- P1 appears in the display window
- Room temperature is lower than
the set temperature.(Cooling mode)
- The windows or doors in the room
are not closed.
- There are heat sources inside the
room.
- Exhaust air duct is not connected or
blocked.
- Temperature setting is too high.
- Air filter is blocked by dust.
- The ground is not level or not flat
enough.
- The sound comes from the flowing
of the refrigerant inside the
air-conditioner.
- The automa tic over heat
protection function. Wh en the
temp erature at the air outlet
O O
exceed 70 C/158 F,the device
will stop.
SUGGEST REMEDIES
Drain the water in the bottom tray.
Reset the temperature.
Make sure all the windows and
doors are closed.
Remove the heat sources if possible.
Connect the duct and make
sure it can function properly.
Decrease the set temperature.
Clean the air filter.
Place the unit on a flat, level
ground if possible.
It is normal.
Switch on again after the unit
has cool down.