General Safety Information; General Safety Instructions - MBM GF4772V Instructions Pour L'installation

2.
GENERAL AND SAFETY INFORMATION

General safety instructions

Every technical change has an effect on the operation or safety of the appliance and must
therefore be performed by technical personnel of the manufacturer or by technicians who
are formally authorised by the same. Failure to do so exempts the manufacturer from any
liability for for any possible resulting modifications or damage.
Upon arrival, check the integrity of the appliance and its components (e.g. power cord),
prior to use. In the presence of faults do not start the appliance and contact the nearest
service centre.
Before making the connections check the technical data shown on the rating plate of the
appliance and the technical data in this manual.
Locking devices must be installed on the supply lines (Electricity-Gas-Water) upstream of
the appliance that exclude the power whenever it is necessary to operate safely.
Connect the appliance in sequence to the water and drain network then to the gas net-
work. Ensure there are no leaks then proceed with the connections to the mains.
The appliance is not designed to work in an explosive atmosphere and as such its instal-
lation and use is categorically prohibited in such environments.
Position the entire structure, respecting the installation dimensions and characteristics
indicated in the specific chapters of this manual.
Note!
• The appliance is not intended for recessed installation.
• The appliance must be used in a well ventilated area.
• The appliance must have free drainage (not hindered or impeded by foreign bodies).
The gas equipment must be installed beneath an extraction hood whose system must
have specifications in compliance with the current regulations in the country of use.
Once the appliance is connected to the power and drain sources, it must remain static
(fixed) in the place of use and maintenance. Incorrect connection may cause danger.
Use where appropriate flexible cable for connection to the mains electricity supply with
characteristics not inferior to the type with rubber insulation model H07RN-F. The supply
voltage supported by the cable with the appliance working must not differ from the nominal
voltage value ± 15% shown at the bottom of the technical data table.
The appliance must be included in an "Equipotential" ground discharge system.
Drainage of the appliance must be conveyed into the grey water discharge network in an
open "glass" unsiphoned formation.
The appliance must only be used for the purposes indicated. Any other use must be con-
sidered "IMPROPER" and therefore the manufacturer declines all liability for any conse-
quent damage to persons or property.
Particular safety prescriptions (obligation-prohibitions-danger) are detailed in the specific
chapter concerning these issues.
Do not obstruct the heat extraction and/or dissipation openings.
The appliance has to be installed and used in such a way that any water cannot contact
the fat or oil.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 6 - 6