Attaching The Wing To The Harness With The Lower Screws; Attaching The Wing To The Harness With The Upper Screw - Scubapro X-Tek Mode D'emploi

Masquer les pouces Voir aussi pour X-Tek:

Table des Matières

Les langues disponibles

Threading the bungees on the wing:

1) Thread the bungee through the loop on the top of the

wing's back

Attaching the wing to the harness with the lower screws:

1) Insert the female screw through the second grommet

on the top of the harness's inside

2) Thread the bungee through the upper grommet of the

harness

3) Now attach the bolt snaps to the bungee using the

knot in pic. B

1) Insert the screw through the lower attachment points

of the wing and thread through the small grommets on

the lower part of your harness. Fix the screw with the

washer and the nut on the inside of the harness

2) If optional weight attachment strap is used, please

attach it between wing and harness. Then secure with

the male screw and tighten j rmly

Table des Matières

Table des Matières