Assembling The Shoulder Straps On The Plates - Scubapro X-Tek Mode D'emploi

3) Thread the belt through the second loop
5) Insert the belt through the j rst eye of the shoulder strap
attachment plate
7) Attach the waist belt D-ring to the belt

Assembling the shoulder straps on the plates:

1) Thread the shoulder strap through the upper eye on
the shoulder strap attachment plate that sits on your
waist belt
12
4) Pull the belt to make the wing sit j rmly on the harness
6) Thread the belt through the second eye of the shoulder
strap attachment plate and pull the belt to sit j rmly
8) On the left belt please attach the waist belt buckle as
seen on the picture
9) Repeat this procedure on the other side of the harness
2) Attach the belt stopper to the strap after adjusting the
length as needed