Using Convect Full Meal - KitchenAid KERI500 Guide D'utilisation Et D'entretien

U
sing and Caring for Your Oven

Using Convect Full Meal

(Thermal-Convection™ models)
Convect Full Meal lets you choose from among ten preset oven cooking cycles. These cycles
store commonly used cooking times, cooking temperatures, and probe temperature settings.
Convect Full Meal saves you time by limiting the number of pads you have to press when
cooking at a favorite setting.
1. Place food in cold oven.
If you need the Temperature Probe for
your cycle (settings 5-8), insert probe
into food. (Follow Steps 1-4 in the "Using
the temperature probe" section.)
2. Set CONVECT FULL MEAL cycle.
Press desired Number pad.
(Use the "Convect Full Meal chart" as
your guide for selecting the correct
cycle.)
NOTES:
• You can change the Convect Full Meal
cycle any time before pressing START/
ENTER by repeating Step 2.
3. Start oven.
PRESS
NOTE: Cycles 1-4, 9, 0: To see the time
when the CONVECT FULL MEAL cycle
will end, press STOP TIME.
When the Convect Full Meal cycle is
done, "End" and the time of day will show
in the display. Four tones will sound,
followed by one short tone every minute,
until you open the door, remove the
probe, or press CANCEL/OFF.
34
PRESS
CONVECT
FULL
MEAL
Example:
PRESS
1
START
ENTER
YOU SEE
DELAY TIMED
CLEAN LOCKED
DEHYD ROTIS
START?
Example:
YOU SEE
DELAY TIMED
CLEAN LOCKED
DEHYD ROTIS
START?
• The cooking setting, time, or probe
temperature will be displayed before you
press START/ENTER.
Example
For Auto
Set 5:
YOU SEE
DELAY TIMED
CLEAN LOCKED
DEHYD ROTIS
START?
Example:
YOU SEE
DELAY TIMED
CLEAN LOCKED
DEHYD ROTIS
START?
ON
HR MIN MIN SEC
CLEAN START STOP TIMER
ON
HR MIN MIN SEC
CLEAN START STOP TIMER
ON
HR MIN MIN SEC
CLEAN START STOP TIMER
ON
HR MIN MIN SEC
CLEAN START STOP TIMER