Installation Of The Appliance - BORETTI M-system MI-602 Mode D'emploi

INSTALLATION OF THE APPLIANCE

WARNING:
The electrical connection of this hob should be carried out by a qualified electrician, according to
the instructions in this guide and in compliance with the current regulations. In the event of any
damage that occurs as a result of improper connection or installation, the warranty will not be valid.
This appliance must be earthed.
Installation safety
· Any overhanging surface should be at least 65cm above the hob.
· Extractor fans must be fitted in accordance with the manufacturer's instructions.
· The wall in contact with the rear of the hob must be made of flameproof material.
· The power cable length should not exceed 2 metres.
Fitting the hob into a work surface
· The hob can be inserted into any worktop provided it is heat resistant up to at least 90ºC.
· Create an opening with the dimensions shown in the picture below and on next page.
· Induction hob may be built in the 25 to 40 mm thick worktops.
60cm induction hob
13