BORETTI M-system MI-602 Mode D'emploi page 54

When the timer has run down, a signal sounds and the timer display shows "00" statically, the
assigned cooking zone timer LED blinks. The programmed cooking zone will be switched off and the
"H" will be displayed if the cooking zone is hot.
The sound signal and the blinking of the timer LED will be stopped automatically after 2 minutes
and/or by operating any key.
Buzzer :
While the hob is in operation, the following activities will be signalled by means of a buzzer:
· Normal key activation with a short sound signal
· Continuous operation of keys over a longer period of time (10 seconds) with a longer,
intermittend sound signal.
Boost Function :
A cooking zone has to be selected, cooking level set to „desired cooking level" and P(Boost) key
has to be pressed again.
Boost-Function can be activated if the induction module accepts the setting on this cooking zone If
Boost Function is active a „P" is displayd on the corresponding display.
Activating the booster can exeed the maximum power and the intergated power management will
be
activated .
The neccessary power reduction is shown by blinking of the correpsonding cooking zone display.
Blinking is active for 3 sec. and allows further adaptations of the settings before power reduction.
10