Measuring; Toggling The Measured Value Display; Adjusting The Temperature - Knick Portavo 908 MULTI Instructions

Measuring

Once you have completed all preparations, you can start with the actual measure-
ment.
1) Connect the desired sensor to the meter. Some sensors require a special
preparation. Please proceed according to the operating instructions for the
sensor.
2) Switch the meter on using the on/off or meas key.
3) Depending on the measurement method and the sensor used, immerse
the sensing part of the sensor in the medium to be measured.
4) Watch the display and wait for the reading to stabilize.
Note: Measurement can also be controlled via the Paraly SW 112 software.

Toggling the Measured Value Display

During measurement, you can toggle between display of
primary / secondary measured values and clock by pressing meas.

Adjusting the Temperature

When you connect a sensor without temperature detector, you can manually adjust
the temperature for measurement or calibration:
1) Press meas to access measuring mode. The adjusted temperature will be
displayed.
2) Set the desired temperature value using the  or  arrow. Holding the key
depressed changes the temperature value at high speed.
pH ORP
31
Oxy Cond