Safety Concept; Intended Use - FLUX VISCOFLUX lite Ex Notice D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Attention!
When
there is a danger of crushing in the area of the edge of the drum and the
pump-centring bore.
Attention!
Medium can continue to flow from the hose after the pump has been
switched off. This medium must be removed in such a way that there is
no hazard for persons or the environment.
2.5

Safety concept

The aims of the safety measures are as follows:
To protect personnel from injury
To protect the mobile drum emptying system against damage or standstill
To protect the environment
To achieve this, the following measures have been implemented:
Protective features
Holding hose with arresting hook between follower plate and drum edge.
Double handles on the follower plate and pump centring plate facilitate and
secure handling.
Safety information on the equipment and in the operating instructions
The drum emptying system may only be used by authorised personnel.
3

Intended use

The drum emptying system VISCOFLUX lite Ex is used for the convenient emptying
of highly viscous, just flowing media from ISO drums with lids.
Barrels with inliner must not be used.
In an environment subject to explosion hazard pumps and motors are used which
have been checked and approved according to the Explosion Protection Directive
2014/34/EU.
Emptying must be performed under supervision.
The drum emptying system must not be exposed to weather.
Resistance to chemicals must be considered.
The drum emptying system must always be adapted to the material to be pumped
(see resistance chart).
When changing the material to be pumped, internal instructions must be observed.
Take into account any possible chemical reactions and any hazards to health and
material damage that can result from these.
Failure to observe the above can lead to damage to the drum emptying system and to
injury to operating personnel.
Ex-Marking
The Ex-marking of the VISCOFLUX lite Ex is:
II 1G IIB TX
Information
The actual maximum surface temperature does not depend on the
drum emptying system but on the ambient conditions, the medium
temperature and the used devices (e.g. pump).
30 / 72
placing
or removing the follower plate or on pump installation,
Operating instructions VISCOFLUX lite Ex

Publicité

Table des Matières
loading

Table des Matières