Fein AFSC18Q Serie Mode D'emploi page 14

OBJ_BUCH-0000000363-001.book Page 14 Wednesday, January 30, 2019 10:02 AM
en
14
Assembly instructions.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
For all work or when changing application tools, always wear protective gloves.
CAUTION
Danger of injury from the sharp edges of the application tools. Application
tools can become very hot while working. Danger of burns!
Removing and charging the battery
(figure 2).
Prior to the first charging procedure,
read the operating instructions of the
battery charger.
Charge the battery completely before
putting into operation for the first time.
Release the battery by pressing the battery-
unlocking button and pull the battery out of
the handle. Do not exert any force when
doing this.
Connect the battery charger to a socket out-
let, slide the battery onto the battery charger
and charge the battery. After the charging
process is over, insert the battery into the
power tool and pull the plug of the battery
charger out of the socket outlet.
A new battery does not reach its full capacity
until after several charging and discharging
procedures.
Mounting the depth stop (figure 3).
Mount the depth stop with the 2 screws to
the bottom side of the gear case.
Fig. 2
Battery-Unlocking button
2.
Fig. 3
Depth stop
Battery
1.
1.
2.
Screws