Abicor Binzel iSTM Mode D'emploi page 43

iSTM
12 Disposal
12.1 Materials
12.2 Consumables
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power source.
• Close off the compressed air supply.
• Switch off the entire welding system.
• Pull the mains plug.
NOTE
• Observe the information given in section
• 8 Putting out of operation auf Seite EN-16.
1 Disconnect the cable assembly from the wire feeder.
2 Open the lock ring, unscrew the fastening screw.
 6.2.2 Mounting the cable assembly on the robot auf Seite EN-11
3 Pull out the cable assembly.
4 Disconnect the torch neck and remove it.
 6.3 Attaching the ABIROB® A torch neck auf Seite EN-13
 6.4 Attaching the ABIROB® W torch neck auf Seite EN-14
5 Dismount the iSTM from the robot.
 6.1 Fastening the iSTM to the robot auf Seite EN-9
For the disposal observe the local regulations, laws, provisions, standards and
guidelines. For the iSTM to be properly disposed of, it first must be dismounted.
 See
 11 Dismounting auf Seite EN-20
This product consists for the most part of plastics, steel and non-ferrous metals.
Steel and non-ferrous metals can be molten in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are marked in
preparation for sorting and separation of the materials for later recycling.
Oil, grease and cleaning agents must not contaminate the ground or enter
sewage systems. These materials must be stored, transported and disposed of
12 Disposal
EN - 21