Abicor Binzel iSTM Mode D'emploi page 36

6 Putting into operation
6.4 Attaching the ABIROB
1
®
1 ABIROB W torch neck
2 Positioning pin
Abb. 7 Attaching the ABIROB
EN - 14
®
W torch neck
3 iSTM fastener
4 Connection module
®
W torch neck
®
1 Equip the ABIROB
nozzle.
2 Introduce the positioning pin (2) into the marked bore.
®
The ABIROB W torch neck (1) can only be fastened in this position.
3 Tighten the ABIROB
NOTE
• After using the torch for a prolonged period, it may happen that it can no
longer be disconnected by hand. To do this, a suitable wrench is
available. Do not use pliers to disconnect the torch.
2
5
5
W torch neck (1) with tip adaptor, contact tip and gas
®
W torch neck (1) with the nut (5) to the iSTM (3).
3
4
Nut
iSTM