Alarm Function - Conrad Renkforce 1423362 Mode D'emploi

e) Alarm function
Selecting and setting the alarm times 1 and 2
• Push the button "CLOCK SET" (B7) briefly several times to switch between display of
the date, alarm time 1 (display "AL1") and alarm time 2 (display "AL2") (C11).
• To set an alarm time, either switch to alarm time 1 "AL1" or alarm time 2 "AL2". While
an alarm time is displayed, keep the button "ALARM SET" (B3) pushed for 2 seconds,
so that the hours of the alarm time start to flash.
• Set the hours of the alarm time with the button "CH +" (B4) or "MEM -" (B6). Keep the
respective button pressed for quick adjustment.
• Briefly push the button "ALARM SET" (B3); the display of the alarm time minutes will
flash. • Set the minutes of the alarm time with the button "CH +" (B4) or "MEM -"
(B6) as well.
• Push the button "ALARM SET" (B3) again briefly to leave the setting mode and save
the alarm time. If you do not push any button for approx. 1 minute, the setting mode is
left as well and the currently set alarm time is saved.
After completing the setting mode, the currently set alarm is activated auto-
matically.
Switching the alarm function on/off
Method 1:
• Push the button "CLOCK SET" (B7) several times until either the alarm time "AL1" or
"AL2" is displayed (C11), depending on which alarm time you want to switch on or off.
• Briefly push the button "ALARM SET" (B3) to activate or deactivate the desired alarm
function.
48