Spa Set-Up - mspa Alpine Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SPA SET-UP

1.
Move the entire package to a selected site. Open the carton carefully as it can be re-used to store the spa
during long term storage or when not in use.
2.
Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tub is
right side up. (*For missing or damaged part, contact the MSpa Service Center)
1
NOTE:
D-NE02: For this model, a side bar is included in
the package. Set up the wicker bar and place the
supporting legs underneath the spa tub before
filling the water. It helps keeping the oval spa in a
proper shape after water filling and inflation.
D-AL04/06, D-TE06:
Spread out the square
ground mat and place it to
the selected site. Make
sure the buckle of cover
and mat is attached when
spa not in use.
3.
Spa Inflation
3.1 Plug the spa into the grounded supply socket.
3.2 Press RESET button on the PRCD, the screen on controller shows numbers.
the controller to start inflating until the yellow section of the manometer is pushed out.
3.4 Stop pressing bubble button and turn the knob back to <OFF> .
3.3
ON
2
°C
BUBBLE
HEATER
FILTER
BUBBLE
TIMER
UP
DOWN
this side
face down
Yellow
12
3.4
OFF

Publicité

Table des Matières
loading

Table des Matières