mspa Alpine Manuel Du Propriétaire page 16

Adjustment Buttons:
Re-set the temperature within 3s. Otherwise the temperature setting mode will automatically end. If
UP
other button is pressed during the setting , the setting will also stop. The current temperature
shown on the screen is confirmed.
DOWN
NOTE: Default setting temperature is 40°C; Temperature setting range: 20 - 42°C.
Controller Locking: Press UP and DOWN button at the same time for 3s, the buzzer will ring 3
times, meaning that the controller is locked. In this mode, function will not be turned on if the button
is pressed. Press UP and DOWN button at the same time again for 3s to unlock the controller.
Timer Button:
DOWN button, you can set and start heating automatically in up to 99 hours. The TIMER setting is
TIMER
confirmed if no further operation in more than 3s or press TIMER button again. The heater will start
working after current setting hours. The setting hour can also be changed by entering the
pre-setting mode again. The light of TIMER button flashes green when activated.
Cancel: Press the TIMER button for 3s to cancel the pre-setting.
NOTE: The pre-setting function cannot be turned on during heating process. The pre-setting mode
will also end after heating function is on or after the spa is reboot.
Filter Cartridge Cleaning Reminder: When red light keeps flashing (Filter function is OFF) or
red and green lights alternately flashing(Filter function is ON), the filter cartridge shall be
cleaned or replaced. After that, press Filter button for 3s to delete the reminder.
MAINTENANCE
Filter Cumulative use up to 150hrs, or cleaning
Cartridge reminder is activated
Not in used for 2~3 days or longer
SPA
Check water quality in time and adjust to
recommended range
ERROR CODE CHART
LED
READING
Water temperature is lower than zero degree
E0
or exceed 55°C
Temperature sensor failure
E1 immediately shows after pressing
FILTER or HEATING
E1
E1 shows 15s after pressing FILTER
or HEATING
Press UP or DOWN button, the screen flashes setting temperature.
Press the TIMER button to enter intelligent pre-setting mode. By press UP and
FREQUENCY
CAUSE
Clean the filter cartridge or change a new one
Use an overall cover for protection
Use water treatment products to adjust
Adjust water temperature
Contact the MSpa Service Center.
Clean parts and tubes that water goes through
1. Add more water to the minimum line;
2. Clean parts and tubes that water goes through;
3. Contact the MSpa Service Center.
16
ACTION
SOLUTION