Resetting The Factory Settings - VOLTCRAFT CPPS-320-42 Mode D'emploi

14. rESETTINg ThE fACTory SETTINgS

1. Hold the mENu (8) button for approximately 3 seconds.
2. Turn the setting controller VoLTAgE (4) until the following display appears
3. Then press the setting controller VoLTAgE (4) to reach the setting mode.
4. Turn the CurrENT (5) setting controller. "Yes" or "No" appears in the right display.
5. Select "Yes" and then press the setting controller VoLTAgE (4) to confirm the selection and return to the setting
mode.
6. Then press the mENu (8) button, to leave the setting mode The laboratory network device starts again with the
values set by the factory.
57