VOLTCRAFT CPPS-320-42 Mode D'emploi page 51

for example:
You want to set the transit time between the voltage sources A and B.
1. Press and hold the mENu (8) button for approximately 3 seconds.
2. Turn the setting controller VoLTAgE (4) until the following display appears:
3. Then press the setting controller VoLTAgE (4) to reach the setting mode.
4. Turn the setting controller VoLTAgE (4) until the following display appears:
5. Turn the setting controller CurrENT (5) until the following display appears:
6. Press the setting controller VoLTAgE (4), to confirm the selection.
7. The transit time between the voltage source A and B now amount to 5 seconds.
8. Repeat the steps 1 to 4 for the other voltage ranges.
Transit times of 0 to 20 seconds can be set.
51