Mounting Weights (Optional Accessories); Mounting Pad - Cleanfix E50x35 Excenter Mode D'emploi

Mounting weights (optional accessories)

➀ Screw the 4 threaded rods into the base plate using an SW8 open-end wrench.
➁ Place the plastic base (paint protection) over the threaded rods on the base plate.
➂ Push the weights onto the threaded rods as far as they will go and screw them tight with the star grips.
E50x35 Excenter
➀
➁
Option number of weights
1 pair 2 pairs

Mounting pad

This assembly is the same for the eccentric E50x35 and E44,
pictured is E50x35.
• Make sure that the power plug is not plugged in.
• Select the pad suitable for the cleaning task.
• Swivel the motor head upwards into the vertical position by
lifting it by the handle.
• Center the pad on the drive plate and press it down.
• Swing the motor head down again.
➀
➂
3 pairs
E44 Excenter
➀
➁
1 pair 2 pairs
➀
➂
3 pairs
| 19