Lighting; Battery Of The Remote - Atag CU90511RM Notice D'utilisation

MAINTENANCE

Lighting

Battery of the remote

Active carbon filters:
The regenerable active carbon filter must be washed by hand with
neutral cleaning products, or in the dishwasher at a maximum
temperature of 65 °C (the washing should be done without any plates,
dishes, cups, etc. in the machine). Without washing detergent.
Remove the excess water without damaging the filter, remove the
holder and let the filter dry in the oven for at least 40 minutes at a
maximum temperature of 70 °C.
To keep the regenerable carbon filter efficient, this action should be
repeated every 2 months or when indicated by the filter indicator. The
filter must be replaced after no more than 3 years, or if it has been
damaged.
It is important that the grease filters and the regenerable active
carbon filter are thoroughly dry before repositioning.
Replacing the carbon filter:
To replace the carbon filter, consult the manual for the recirculation kit.
Attention!
The hood is fitted with LED lights. These must be replaced by an
authorized technician. Do not attempt to replace the LED lights
yourself.
Important!
When the batteries are replaced the pairing connection will remain.
Replace the batteries in time, as the receiving distance will be
shortened if the voltage of the battery is too low.
Don't forget to remove the batteries if you don't use the remote for a
long time.
Don't leave the remote lying upside down on a conductive surface.
The warranty does not cover the batteries.
The battery may drain more quickly in connection with the lit icons.
Battery specifications: Two AAA batteries
EN 13