Flashing Installation; Trivet Installation - Napoleon NPS45 Instructions D'installation Et D'opération

30
6.2

flashing installation

EN
Secure the right flashing to the
A.
right side of the appliance using
2 of the #8 x 1/2" screws.
Remove the 2 control panel
B.
securing screws, discard the
screws and shipping bracket.
Secure the control panel to the
C.
right flashing using the 2 #8
x 3/8" screws. Secure the left
flashing with the remaining #8 x
1/2" screws.
Align the holes in the top of
D.
the right and left flashing with
those on the bottom lip of the
Top Flashing and secure from
the rear using the 4 #8-32 x 3/8"
screws, washers and nuts.
The 3 pieces of trim are
E.
assembled in the same manner
as a picture frame. Place the
corner brackets (with screw
loosened) into the trim sections.
Tighten the screw spreading
the 2 pieces apart. Attach the
adjoining section. Repeat with
the opposite side. Tighten all
screws firmly.
Slide the assembled trim down
F.
over the flashing.
Affix the logo to the bottom left
G.
hand corner of the left flashing.
6.3

trivet installation

The trivet for the insert is attached by 2 set screws on the inside of the hopper lid.
W415-1472 / B / 02.05.18
TRIM
UNDERSIDE
SET SCREW
SET
SCREW
SHIPPING
BRACKET
CONTROL
SECURING
PANEL
SCREWS
RIGHT
FLASHING
CORNER
BRACKET
CONTROL
PANEL
SECURING
SCREWS
TOP
FLASHING
TRIM
ASSEMBLY