Water Connection - Kärcher HD 9/21 G Mode D'emploi

Masquer les pouces Voir aussi pour HD 9/21 G:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
Install hand spray gun, spray lance
and nozzle
Note: The EASY!Lock system joins com-
ponents with a quick-fasten thread solidly
and securely with just one turn.
1.
 Insert the high pressure nozzle onto the
spray lance.
 Install union nut and hand-tighten it
(EASY!Lock).
 Join the spray lance with the trigger gun
and tighten until hand-tight
(EASY!Lock).
 Tighten the screw connection of the
spray lance finger tight.
 Join the high-pressure hose with trigger
gun and high-pressure connection of
the appliance and tighten until hand-
tight (EASY!Lock).
Check oil level of the high pressure
 Check oil level of the high pressure
pump at the oil sight glass.
Do not operate the device if the oil level has
fallen below the middle of the oil sight glass.
 Add oil if required (see technical speci-
fications).
18
2.
pump
 Before using for the first time, cut off the
tip of the lid of the oil tank on the water
pump.
Follow the instructions given in the sec-
tion "Safety Notes"!
 Read the operating instructions of the en-
gine manufacturer before start-up and fol-
low the safety instructions carefully.
 Check oil level of the engine.
Do not operate the appliance if the oil
level has fallen below "MIN".
 If required, top up oil carefully.
 Fill the fuel tank with unleaded petrol.
Do not use 2-speed mixture.
E10 fuel may be used.
DANGER
Risk of fire and explosion!
– Never use the appliance in closed
rooms; do not tank up when the engine
is hot or running.
– Do not smoke during fueling.
– Never fill up in the vicinity of open
flames or sparks.
– Do not spill any fuel – use a funnel.
– Wipe up spilled fuel.
– After refuelling, properly close the can
and tank.
 Fill the fuel tank with unleaded petrol.
Do not use 2-speed mixture.

Water connection

For connection values refer to technical
specifications.
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4") to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
 Open the water supply.
Note: The supply hose is not included.
Suck in water from vessel
DANGER
Never suck water from a drinking water
container.
– 4
EN
Motor
Refuel

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hd 9/23 g

Table des Matières