Water Connection - Kärcher HD 2.3/15 C Ed Mode D'emploi

Check the power cord with mains plug
for damage before every use. If the
power cord is damaged, please ar-
range immediately for the exchange by
an authorized customer service or a
skilled electrician.
The plug and coupling of the extension
cable used must be watertight.
Use the extension cord that has an ad-
equate cross-section (see "Technical
Data") and unwind it fully from the ca-
ble drum.
Unsuitable extension cables can be
hazardous. Only use extension cables
outdoors which have been approved
for this purpose and labelled with a suf-
ficient cable cross section:
For connection values, see type plate/
technical data.
GFCI INSTRUCTIONS
STEP 1: Plug the Ground Fault Cir-
–
cuit Interrupter (GFCI) into a work-
ing outlet.
STEP 2: Press ''TEST'', then press
–
''RESET'' to assure proper connec-
tion to power.
Note: The actual appearance of the
GFCI may be different from this illus-
tration.
8

Water connection

Connection to the water supply
Warning
Observe regulations of water supplier.
According to the applicable
regulations, the appliance
must never be used on the
drinking water supply without a system
separator. Use a suitable system sep-
arator manufactured by KÄRCHER; or,
as an alternative, a system separator
as per EN 12729 Type BA. Water flow-
ing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator
to the water supply, never directly to
the appliance!
For connection values refer to techni-
cal specifications
Connect the supply hose (max

length 7.5 m, minimum diameter 1/
2") to the water connection point of
the machine and at the water sup-
ply point (for e.g. a tap).
Note
The supply hose is not included.
Open the water supply.

Drawing in water from open reservoirs
Screw the suction hose with filter

(order no. 4.440-238.0) to the water
connection.
Deaerate the appliance:

Unscrew the nozzle.
Switch on the appliance and let it run
until the water exiting is bubble-free.
At the end let the appliance run for
approx. 10 seconds - then switch
off. Repeat the procedure for a cou-
ple of times.
Switch off the appliance and fit the

nozzle again.
– 6
EN