Human Touch Perfect Chair PC-420 Mode D'emploi Et D'entretien page 7

5. Place the control panel into position on the armrest, above the chair arm as shown (Fig.9).
Fig.9
6. While holding the housing firmly in place, place the arm cap into position and press down firmly (Fig.10).
Arm cap
Fig.10
humantouch.com
10
7. While pressing down on the armrest cap, secure it using the provided Phillips-head screwdriver
and three screws (Fig.11).
Front
Fig.11
8. Using a Phillips-head screwdriver, remove the screw and washer that secure the left-hand glide rail safety
tip (Fig.12).
9. Place the control panel cable loop into position over the screw hole, then replace the screw and washer
to secure it. (Fig.12).
10. Place the cap into position on the right-hand armrest core, then secure it using three screws.
Screw
Washer
Cable loop
Fig.12
Rear
Glide rail safety tip
11