Human Touch Perfect Chair PC-420 Mode D'emploi Et D'entretien page 6

6. Plug the transformer into the right-hand power hub receptacle (Fig.5).
Fig.5
7. Feed the transformer cable up through the cable guide then up through the hole in the chair
canvas (Fig.6).
8. Gently return the chair to the upright position.
Fig.6
humantouch.com
Plug in transformer
Feed transformer cable
8
Install the control panel
1. Remove the six screws taped to the underside of the left-hand armrest cap.
2. PC-600/610: Note the shape of the top of the recline controller panel and the matching shape of the
recline controller housing (Fig.7).
Recline controller housing
3. PC-600/610: Place the housing into position on the left-hand armrest as shown (Fig.8).
4. PC-600/610: Make sure the matching shapes are tightly aligned to ensure that the knob is centered
in the housing.
Recline controller panel
Fig.7
Recline controller housing
Fig.8
9 9