Human Touch Perfect Chair PC-420 Mode D'emploi Et D'entretien page 8

11. Slide the body pad onto the footrest frame, making sure the frame slides into the pockets on the
bottom corners of the pad (Fig.13).
12. Fold the upper part of the pad forward onto the seat (Fig.13).
13. Locate the following cables:
• Cable coming through the seat canvas (from the transformer plugged into the power hub) with red wiring.
• Two cables coming from the pad set with black and yellow wiring.
Upper part of the pad
Red cable from seat canvas
Fig.13
humantouch.com
Footrest frame installed all
the way into the pocket
Black and Yellow cables
from pad set
12
14. Matching the wire colors, connect the three connectors to the corresponding connectors in the connector
box attached to the control panel cable. (yellow/yellow, red/red, black/black) (Fig.14).
15. Install the three cable strain reliefs into the connector box slots, push them all the way down,
then snap the connector box cover into place to secure it (Fig.14).
16. Tuck the connector box into the seat canvas.
Red transformer cable
from power hub
Black lumbar system
cable from pad set
Yellow jade heat cable
from pad set
Fig.14
13