Human Touch Perfect Chair PC-420 Mode D'emploi Et D'entretien page 5

put it together
NOTE: The illustrations in this section show a PC-600/610. If you are installing the upholstery package
on a PC-420 it will look different underneath the chair and on the left-hand armrest.
Install the power hub
1. Gently tip the chair forward onto the footrest (Fig.1).
2. Locate the four screw holes on the rear of the front cross bar.
Fig.1
3. Using the provided Phillips-head screwdriver and screws, secure the power hub to the chair with the
power cord facing to the right (Fig.2).
Fig.2
humantouch.com
Front cross bar
Power hub
6
4. PC-600/610: Coil the chair power cord neatly, open the pocket on the bottom of the chair canvas, then
tuck the coiled cable into the left-hand inside pocket with the plug positioned at the top (Fig.3).
Coiled
power cord
Pocket
5. PC-600/610: Pull the plug gently out of the pocket, guide the cable through the two cable guides on
the chaircanvas, plug it into the left-hand power hub receptacle, then close the canvas pocket using
the hook-and-loop fasteners (Fig.4).
Fig.4
Fig.3
Plug in cable
7 7