Terminal Control; Keypad Control - Leroy Somer DIGIDRIVE SE Guide De Mise En Service

As default - in positive logic (connect terminals to +24V to activate).
0 5
Parameter 0 5 set to " A1. A2 ".
10kΩ
(2kΩ min)
4-20mA
+24V
0V
Connect terminals 7 and 9
0 5
Set parameter 0 5
If reverse is required, set parameter 1
2 6
Set parameter 2 6
speed. Press
NOTE! When parameter 0
functionality.
DIGIDRIVE SE - Quick start

Terminal control

1 0V common
2 Local voltage speed reference input (A1)
3 +10V reference output
4 0V common
5 Remote current speed reference input (A2)
6 Analog output 0-10V (Motor speed)
7 +24V output
8 Digital output (Zero speed)
9 Drive Enable
10 Run Forward
11 Run Reverse
12 Local (A1) / Remote (A2) speed reference
13 Jog Select
14 +24V output
15
Drive healthy relay
16

Keypad control

to " PAd ".
to " On " to enable
key to go. Press
0 5
5 is set to " PAd ", terminals 12 and 13 do not have any
7 +24V
9 Drive Enable
1 0
0 to " L2 ".
key. Use
key to reverse and
and keys to increase/decrease
key to stop.
9