Selecting And Changing Parameters; Status Mode - Leroy Somer DIGIDRIVE SE Guide De Mise En Service

Sign LED
Run key,
Use to start drive
in keypad mode.
Increase and
decrease keys
Use to select and edit parameters,
also to vary motor speed in keypad control.
M
2 sec
4 min
To return from Parameter Edit mode to Parameter View mode, press the
When in Parameter View mode - either press the
rameter to change, then press the
key to return to Status mode.
display and keypad
M

Selecting and changing parameters

M
or
M
or
M
Stop / Reset key,
Use to stop the drive in keypad mode
and to reset the drive in any mode.
Forward/Reverse key,
Use to reverse motor direction in
keypad mode when bit parameter 26 = On.
Mode key,
Use to change mode
of operation of display.
Parameters are saved each time
the Mode key is pressed.

Status Mode

M
Parameter View Mode
(left hand display flashing)
Select parameter to change
M
Parameter Edit Mode
(right hand display flashing)
Change parameter value
or
key to enter Parameter Edit mode or press the
key once.
M
keys to select another pa-
M
11