Publicité
Les langues disponibles
Les langues disponibles
3 41 01 132 06 0.book Seite 14 Mittwoch, 13. Oktober 2010 12:57 12
en
14
Original Instructions Tapper.
Symbols, abbreviations and terms used.
Symbol, character
Explanation
Do not touch the rotating parts of the power tool.
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
will be danger of injury if the power tool should start unintentionally.
Use eye-protection during operation.
Use ear protection during operation.
Additional information.
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
Product with double or reinforced insulation
Low speed
High speed
Character
Unit of measure,
international
n
/min
0
n
/min
1R
n
/min
1L
P
W
1
P
W
2
M...
mm
mm
Ø
d
mm
1
d
mm
2
kg
mm
L
dB
pA
L
dB
wA
L
dB
pCpeak
K...
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
Unit of measure,
national
rpm
rpm
rpm
W
W
mm
mm
mm
mm
kg
mm
dB
dB
dB
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
2
min, m/s
Explanation
No-load speed (Anti-clockwise)
Speed, full load (Clockwise)
Speed, full load (Anti-clockwise)
Power input
Output
Size of metric thread
Diameter of a round part
Thread size of drilling shaft
Collar diameter
Weight according to EPTA-Procedure 01/2003
Tap
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Vibration emission value (triax vector sum) deter-
mined according to EN 60745
Basic and derived units of measure from the inter-
national system of units SI .
Publicité
