GYS WS-4R Mode D'emploi page 11

DESCRIPTION
The WS4L is a wire feeder suitable for a water cooled torch and designed for use with MIG WS 500. THE WS4R wire feeder is suitable for MIG 400
GR / 500 GR. They work with 200mm reels and 300mm reels.
The unit comes with a swivel support to be mounted on the generator.
DEVICE PRESENTATION (I)
1- Reel support (200 or 300mm)
2- Wire feeder
3- Handle
4- Wire speed potentiometer
5- Euro torch connector
6- Upper section of the swivel support
7- Gas connector of the connecting harness
ASSEMBLY & CONNECTION (I & II)
Installing the swivel support on the generator
Use the 3 screws (included with the generator) supplied to fix the bottom part of the swivel support onto the generator
The upper part of the support is already fixed under the wire feeder.
Connection of interconnection cable:
1
Wire feeder supplied uncovered
4
Insert the power cable
7
Adapt the sheath on the base and tighten
hose clip
WIRE REEL INSTALLATION (III)
• Open the door of the machine.
• Position the reel on to the support (1) taking care of the pin.
• Adjust the break (2), to avoid reel movement tangling the wire when the welding stops.
• Tighten the plastic screw firmly (3).
• For the first use :
- Release the fixing screw of the wire guide (4)
- Put the rollers in place (5). The visible diameter on the roller should be equal to the wire diameter used.
- Place the wire guide (6) as close as possible to the roller but without touching it, then tighten the fixing screw.
WS-4R / WS-4L
8- Control cable connector
9- Power cable connector
10- Eye rings (Don't lift by the handles (3))
11- Setting connection base
12- Hose clamp
2
Fix the base at the back of the wire
feeder.
5
Insert the remaining pipes
3
Insert the command cable
6
Connect the interconnection cable*
*water connection: Only for 500 WS
Generator
Fix power cable with holding device (Fig
2 - 13).
EN
11