Warnings While Using The Machine; Timer - NSS WRANGLER 1503 AE Utilisation Et Entretien

WARNING:
Always lift up the squeegee at the end of
cleaning in order to prevent the deforma-
tion of the rubber blades.
- Disconnect the electric power cable from
the socket (for AE version only).
9.1.e - Warnings while using the ma-
chine (Fig. 12/a)
- While using the machine, the occurrence
of the following errors is signalled by the
coming on of the leds.
Suction unit outlet overcurrent error
Led 1 is flashing and Led 2 is constantly
lit.
Brush unit outlet overcurrent error
Led 1 is flashing and Led 3 is constantly
lit.
Suction unit outlet open circuit error
Led 1 is flashing and Led 4 is constantly
lit.
Brush unit outlet open circuit error
Led 1 is flashing and Led 5 is constantly
lit.
When any of the above mentioned error signals
is displayed, it is necessary to turn off the ma-
chine and then turn it on again, in order to set it
back to normal functioning.
9.1.f - Timer (Fig. 12/a)
It is possible to visualize the working time of
the machine proceeding as follows:
- To turn on the timer it is necessary to start
the machine by pushing the "Brush rota-
tion" button (8) and keeping it pressed.
The timer counts up to 9999 hours.
Indication of the hours of work by units:
- one flash of Led 1 followed by as many
flashes of Led 5 as the units of hours of
work.
Indication of the hours of work by tens:
- one flash of Led 1 followed by as many
flashes of Led 4 as the tens of hours of
work.
Indication of the hours of work by hundreds:
- one flash of Led 1 followed by as many
flashes of Led 3 as the hundreds of hours
of work.
Indication of the hours of work by thousands:
- one flash of Led 1 followed by as many
5
flashes of Led 2 as the thousands of
hours of work.
4
3
2
1
Fig. 12/a
EN-17
NOTE:
NOTE:
EN