Noise And Vibration; Machine Inspection; Machine Operation; Quick Start - NSS CHARGER 2717 DB Instructions D'origine

NOISE AND VIBRATION

NOISE
Sound pressure level at Operator
position (ISO 11201)
VIBRATION
Weighted RMS acceleration value
(ISO 5349)

MACHINE INSPECTION

 Now that the machine is unpacked remember to
recycle all packing materials.
 Inspect the machine for damage or missing
components. If damage is found, contact the
freight company to file a freight claim.

MACHINE OPERATION

General Information
This machine works best with dry polishing or
burnishing. Use mop on restorers rather than spray
buff systems to restore the shine.
Spray buffing is time consuming and uses more pads
because they become loaded with floor finish, which
can cause overloading of the machine's control
system.

Quick Start

Connecting Battery Pack to Machine
When the machine is shipped with batteries, the
machine will arrive with the battery pack
disconnected from the machine.
 Lift up on the handle on the top cover to expose the
battery pack.
 Connect the cable with the Anderson connector
into the Anderson connector mounted to the
machine at the rear of the battery compartment in
front of the control column.
For machines shipped without batteries
 See Battery Installation in the Maintenance Section
later in this manual.
Lower Brush/Pad to Operating Position
68 dB(A)
2
.269 m/s
 Move the front of the machine from/to pad
changing position or operating position by grasping
the handle and moving it to the desired position.
 Turn on master switch (and key switch if so
equipped). Wait until you hear a click, the machine
is now on. See Machine Components for more
information.
 Check that the battery meter is reading in the high
or green range. The machine should be put on
charge if not in the high range. See Charging
Instructions later in this manual.
 Turn on brush switch. See Machine Components
for more information.
 Twist the handle grips forward (away from you) to
activate the Pad and Drive Motors. To move
backward twist the handle grips backward (toward
you). See Machine Components for more
information.
CAUTION: This Machine must be moving at all
times when the pad is rotating or the floor may be
damaged.
Transporting the Machine to Work Site
NSS recommends transporting the machine to the
work site with the front of the machine in the
operating position and the brush switch in the off
position. This will reduce the potential of damage to
the Flexiwall Shield and Pad Driver when moving
through stock/storage rooms and double swinging
doors.
For questions and all information pertaining to
this machine read the rest of this manual.