Rinse Aid; Adding Rinse Aid; Setting The Amount Of Rinse Aid Used; Switching Off Rinse Aid Refill Indicator - Thermador Star Sapphire Serie Manuel D'utilisation

Switching off low salt indicator / water
softening system
S w i t c h i n g o f f w a t e r s o f t e n i n g s y s t e m
If the use of combined detergents with a salt component
impairs the low salt indicator

Rinse Aid

As soon as the low rinse aid indicator
the control panel, rinse aid should be topped off.
The rinse aid is required for stain-free utensils and clear
glasses. Use only rinse aid which the manufacturer
designates as save to use in domestic dishwashers.
Combined detergents with rinse aid component may be
used up to a water hardness of 21° dH (37° fH, 26°
Clarke, 3.7 mmol/l) only. If the water hardness is over
21° dH, rinse-aid must be used.

Adding rinse aid

NOTICE: To avoid oversudsing or clogging, do not
overfill the rinse aid dispenser
with a damp cloth.
Open the rinse aid dispenser
1.
latch of the lid and pulling it open.
Add liquid rinse aid to the dispenser
2.
Do not overfill.
on the control panel or
P
H lights up on
. Wipe up any spills
9*
by pressing on the
9*
until it is full.
9*
the text on the display window at the top
salt for x rinse cycles), the displays can be switched off.
Proceed as described under "Setting water softening
system" and set the value to 0-8. The water softening
system and salt refill indicator are now switched off.
Close the lid. Lid must be fully closed until it clicks in
3.
order to seal.
Wipe up any excess rinse aid that may have puddled
4.
when the dispenser reservoir is full.
This prevents excessive frothing during the next wash
cycle.
NOTICE: Do not fill the rinse aid dispenser
detergent. Doing so will damage the dishwasher.

Setting the amount of rinse aid used

The amount of rinse aid to be dispensed can be set from
0 to 6. Set the amount of rinse aid to be dispensed to 5
to obtain a very good drying result. Do not change the
amount of rinse aid unless there are streaks or water
stains on the utensils. Set a lower level to avoid streaks.
Set a higher level to avoid water stains.
Set the amount of rinse aid as follows:
Open the door.
1.
Press on ON/OFF button
2.
Press Info button
( 8
3.
following text is indicated on the display window at the
top :
@
Scroll with < >
Set with - +
Leave with t 3 sec.
Keep pressing button >
4.
dispenser is indicated on the display window at the top
.
@
Make the selection with setting buttons + -
5.
Press and hold the Info button
6.
The chosen setting has now been stored.
Note: Do not change the amount of rinse aid unless
there are streaks (select lower setting) or water stains
(select higher setting) visible on the utensils.

Switching off rinse aid refill indicator

If the use of combined detergents with a rinse aid
component impairs the low rinse aid indicator
the control panel (enough rinse aid for x rinse cycles),
the displays can be switched off.
Proceed as described under "Setting amount of rinse
aid" and select setting 0.
NOTICE: Using no rinse aid or setting the dispenser to 0
may result in longer cycle times consuming more energy
and water. The higher temperatures can damage fine
china or glassware.
(enough
@
with
9*
.
(
for 3 seconds until the
until the rinse aid
)*
.
X
for 3 seconds.
(8
H
on
13