Publicité
8
AcceleroXEvent
9
AcceleroYEvent
10
AcceleroZEvent
11
12
13
14
15
16
17
EepromUserFault
18
EepromProductFault
19
EepromCalibFault
20
21
Toute information contenue dans ce document est susceptible d'être soumise aux règles de contrôle des exportations européennes, américaines ou de tout autre pays. Il est de la responsabilité du destinataire de ce
document de s'assurer que le transfert ou l'utilisation des données qu'il contient est conforme à toutes les règles de contrôle des exportations en vigueur.
Information contained in this document may be subject to Export Control Regulations of the European Union, USA or other countries. Each recipient of this document is responsible for ensuring that transfer or use of any
information contained in this document complies with all relevant Export Control Regulations.
Meggitt (Sensorex) se réserve le droit de modifier la présente notice sans préavis/ Meggitt (Sensorex) reserves the right to change the specification without any prior notice
NOTICE D'INSTRUCTION / INSTRUCTION MANUAL
NOT043045InterfaceProductB0
GyroXEvent
GyroYEvent
GyroZEvent
unused
BitFault
SysFault
WdtFault
FilterFault
Table 3: Status bytes definition
1 : Roll and/or pitch tilt angle are out of range [-90° ;90°]
0 : No event signalled on X axis accelerometer
1 : An event is signalled on X axis accelerometer (FilterFault, over-
range, uncalibrated or SBIT or CBIT default) or SysFault bit set
0 : No event signalled on Y axis accelerometer
1 : An event is signalled on Y axis accelerometer (FilterFault, over-
range, uncalibrated or SBIT or CBIT default) or SysFault bit set
0 : No event signalled on Z axis accelerometer
1 : An event is signalled on Z axis accelerometer (FilterFault, over-
range, uncalibrated or SBIT or CBIT default) or SysFault bit set
0 : No event signalled on X axis gyrometer
1 : An event is signalled on X axis gyrometer (FilterFault, over-
range, uncalibrated or SBIT or CBIT default) or SysFault bit set
0 : No event signalled on Y axis gyrometer
1 : An event is signalled on Y axis gyrometer (FilterFault, over-
range, uncalibrated or SBIT or CBIT default) or SysFault bit set
0 : No event signalled on Z axis gyrometer
1 : An event is signalled on Z axis gyrometer (FilterFault, over-
range, uncalibrated or SBIT or CBIT default) or SysFault bit set
0 : SBIT and CBIT OK
1 : SBIT and/or CBIT KO
0 : OK
1 : System fault (oscillator, UART default, EEPROM flash write
error, SPI communication error)
0 : User EEPROM zone CRC OK
1 : User EEPROM zone CRC NOK or at least one data out of range
0 : Product EEPROM zone CRC OK
1 : Product EEPROM zone CRC NOK or at least one data out of
range
0 : Calibration EEPROM zone CRC OK
1 : Calibration EEPROM zone CRC NOK or at least one data out of
range
0 : OK
1 : Microcontroller watchdog default
0 : Internal filters are stable
1: At least one internal filter is unstable. Unstable filter is indicated
by xxxEventBit equal to '1'
- 39 -
Publicité
