Shutting Down/Dismantling; Disposal And Returns - RK Rose+Krieger SQZ-II Notice D'assemblage

7. Working life
Linear unit SQ-II-MT
The toothed belt is tensioned by means of the belt tensioning kit at the end of the guidance sec-
tion.
The toothed belt 1 is tensioned by slackening the retaining screw 2 on the toothed belt tensio-
4
ning plate by approx. A half turn and then turning the tensioning screw 3 clockwise.

7.6 Shutting down/dismantling

Before starting any work on the linear unit, any electrical drives used are to be pro-
tected against accidental switching on.
If a linear unit is installed in an oblique or vertical position, the guidance slide drive must be se-
cured against slipping during dismantling. The system is to be freed from any loads or forces.
Following a collision, the toothed belt, the ball rail guide and the trolley have to be exchanged,
even if there is no visible damage.
Spare parts information is to be taken from the spare parts list for the relevant linear unit type.

7.7 Disposal and returns

The linear unit must either be disposed of in an environmentally friendly way according to the ap-
plicable policies and regulations, or returned to the manufacturer.
The manufacturer reserves the right to charge for disposing of this linear unit.
70
4
2
3
1