Electrical Installation - Briteq LED UV-GUN Mode D'emploi

ENGLISH

ELECTRICAL INSTALLATION

Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Electrical installation for 1 standalone unit:
 Insert the mains cable. The unit starts working immediately in the last selected mode.
 Refer to chapter HOW TO SETUP to learn how to switch between the different working modes.
Electrical installation for two or more units in master/slave:
 Connect the units together using good quality balanced microphone cables. The unit that has no cable
connected to its DMX-input is the "master", the others are the slave units.
 Make sure that all units are connected to the mains.
 Refer to chapter HOW TO SETUP for more information.
 Done!
Electrical installation for two or more units in DMX-mode:
 The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
"daisy chain" your DMX controller and all the connected units with a good quality
balanced cable.
 To prevent strange behavior of the light effects, due to interferences, you must use
a 90Ω to 120Ω terminator at the end of the chain. Never use Y-splitter cables, this
simply won't work!
 Make sure that all units are connected to the mains.
 Each light effect in the chain needs to have its proper start address so it knows which commands from
the controller it has to decode. In the section HOW TO SETUP you will learn how to set the DMX
addresses. Remember that each projector uses 2 channels, a possible address setup could be: unit1 =
001 ~ unit2 = 003 ~ unit3 = 005 ~ unit4 = 007 ~ etc.
HOW TO SETUP:
MAIN MENU:
 To select any of the menu options, press the MODE button up to when the required option is shown on the
display.
 Use the DOWN and UP button to change the parameters of the mode.
BRITEQ
®
4/34
USER MANUAL
LED UV-GUN 60W