Wireless Remote Controller - Briteq LED UV-GUN Mode D'emploi

ENGLISH

WIRELESS REMOTE CONTROLLER

MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input:
Power consumption:
Fuse:
Sound Control:
DMX connections:
LEDs:
Beam angle:
Size:
Weight:
You can download the latest version of this user manual on our website: www.briteq-lighting.com
BRITEQ
®
 DIMMING: You can set the light output at 20%, 50% or 100%.
OFF = Blackout.
 STROBE: You can set the strobe speed at 20%, 50% or 100%.
OFF = No strobe effect.
 D: When you have pressed this button, you can set the DMX
address by usting the + and – buttons.
 SA: Used to start the sound activation. You can use the + and –
buttons to set the sound sensitivity.
 SL: Used to set the projector in SLAVE mode.
 S: used for fast DMX addressing. Press the S button and use the
numeric buttons to set the desired DMX address.
110-240Vac, 50/60Hz
80 Watt
250V 2A slow blow (20mm glass)
Internal microphone
XLR 3pin
60W COB UV-LED
45°
340x130x350mm
3,4 kg
Every information is subject to change without prior notice
6/34
USER MANUAL
LED UV-GUN 60W