Electrical Installation - Briteq BEAMBAR10-RGBW Mode D'emploi

ENGLISH
 255.255.000.000
 255.255.255.000
 Once the correct option shows on the display, press the [ENTER] button to save it.
[DMX UNIVERSE]
Used to set which DMX-universe should be used while controlled via the Ethernet ports.
 Press the [MODE] or ↑/↓buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ↑/↓ buttons to select the desired DMX-universe from 000 to 255.
 Once the correct universe shows on the display, press the [ENTER] button to save it.
Remark: the 512 DMX-channels of the selected DMX-universe are directly available on the DMX-output
without any kind of configuration.
[ETHERNET PROTOCOL]
Used to select which Ethernet protocol you want to use for communication.
 Press the [MODE] or ↑/↓buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ↑/↓ buttons to select the desired Ethernet protocol.
 Once the correct option shows on the display, press the [ENTER] button to save it.
Remark: currently only the Art-Net protocol is supported. Other protocols will follow, see firmware updates.
[FIRMWARE VERSION]
Used to show the current version of the firmware.
 Press the [MODE] or ↑/↓buttons until the FIRMWARE is showing on the display.
The firmware of this unit can be upgraded using a special upgrade tool with Windows® software. (separately
available from Briteq). More information about this can be found in the user manual of the upgrade tool and /
or our website: www.briteq-lighting.com

ELECTRICAL INSTALLATION

Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
STANDALONE WITH BUILT-IN CHASES:
Use this function when you want an instant show on only 1 projector.
 Connect the projector to the mains and turn it on.
 Select one of the following modes in the setup menu:
 SOUND mode: if you want chase programs running to the rhythm of the beat. See the section "setup
menu" for more information on the settings.
 STANDALONE mode: if you want chase programs running automatically but you want a certain
control over the selected chase. See the section "setup menu" for more information on the settings.
 AUTO RUN mode: if you want chase programs running automatically. See the section "setup menu"
for more information on the settings.
STANDALONE MASTER/SLAVE WITH BUILT-IN CHASES:
Use this function when you want an instant show on only 1 projector.
By linking the units in master/slave connection, the first unit will control the other units to show a
synchronized automatic or sound activated light show.
 Connect the projectors as shown in the drawing below
 Setup of the master: exactly the same procedure as the "STANDALONE" setup.
 Setup of the slaves: all slaves should be set to "SLAVE MODE", See the section "setup menu" for more
information on the settings.
BRITEQ
®
9/84
OPERATION MANUAL
BEAMBAR5+10-RGBW