Maintenance; Hood & Grease Filter Cleaning - Zephyr Trapeze CTP-E36CSX Guide D'utilisation, D'entretien Et D'installation

Maintenance

Hood & Grease Filter Cleaning
Surface Maintenance
►
Do not use corrosive detergents, abrasive detergents or oven cleaners.
►
Do not use any product containing chlorine bleach or any product containing chloride.
►
Do not use steel wool or abrasive scrubbing pads which will scratch and damage surface.
Cleaning Stainless Steel
Clean periodically with warm soapy water and clean cotton cloth or micro fiber cloth. Always rub
in the direction of the stainless steel grain. To remove heavier grease build up use a liquid degreaser
detergent.
After cleaning use a non-abrasive stainless steel polish/cleaners, to polish and buff out the stainless
luster and grain. Always scrub lightly, with clean cotton cloth or micro fiber cloth and buff in the
direction of the stainless steel grain.
Cleaning the Grease Filter
The grease filter installed by the factory are intended to filter out residue and grease from cooking.
They need not be replaced on a regular basis but are required to be kept clean.
Remove and clean by hand or in dishwasher using a non-phosphate detergent. Discoloration of
the grease filter may occur if using phosphate detergents, or as a result of local water conditions -
but this will not affect filter performance. This discoloration is not covered by the warranty. Spray
degreasing detergent and leave to soak if heavily soiled.
Dry grease filter and re-install before using hood.
22 Trapeze Use, Care, and Installation Guide
D E S I G N E R
T R A P E Z E
I S L A N D