Zephyr Trapeze CTP-E36CSX Guide D'utilisation, D'entretien Et D'installation page 16

Installation Instructions
Mounting the Range Hood
B
7. Determine desired height of hood, measure and select either 27-3/8" or 35-3/8" angle brackets.
Position and attach angle brackets type A and B to the motor housing as shown using (8) M4*6
screws, (2) for each angle bracket. FIG. D.
8. Slide duct covers over motor housing. Make sure bottom duct cover with cut-out is facing the front
and back of hood. FIG. D.
9. Lift assembled unit and attach all (4) angle brackets to ceiling bracket. Make sure the tabs on
each angle bracket fit between the slots on the ceiling bracket. One half of the angle bracket will
be outside the ceiling bracket and the other half outside the ceiling bracket. Attach angle brackets
to ceiling bracket using (16) M4*6 screws, (4) for each angle bracket. FIG. E.
10. Connect duct work and electrical wiring.
11. Slide up upper duct cover and attach to ceiling bracket using (2) M3*5 screws.
16
A
B
A
FIG. D
B
A
FIG. E
Trapeze Use, Care, and Installation Guide
D E S I G N E R
T R A P E Z E
I S L A N D
B
Tab
A
A