Battery Status Indicator; User Information; Replacing The Joint Brush - Gloria WEEDBRUSH Mode D'emploi


Never clean if others, in particular
children or animals, are in the area!

Never use the device in the rain.
8
Place the device parallel with the guid-
ing wheel and joint brush on the joint
to be treated. Hold the device at work-
ing angle and make sure that the rub-
ber lip on the safety guard (L) is just
above the ground, as illustrated

Make sure that the surface to be
cleaned is free from debris e.g. stones,
screws etc., which could be flung up.
9
Hold the device securely by the handle
(A) and additional handle (E) and
switch on the device by pressing and
holding the ON/OFF safety switch (D)
in handle (A).

In case of work interruptions or
danger, release the ON/OFF safety
switch (D) immediately.
NOTE!

To adjust the safety guard (L), turn the
5 click-stop safety guard to the posi-
7
tion, as illustrated

Align the joint brush with the centre of
the joint, walk at an even steady pace and
push the device in front of you. Adapt
your pace of work to the degree of soiling.

Always work along the joint and hold
the device away from your body.

In cases of stubborn dirt you can move
the device backwards and forwards on
the spot (like a scrubber), until the
required result is achieved.

7.1.1 Battery status indicator

The device is equipped with a battery
charge indicator (B) that displays the
charging status of the battery. The dis-
plays only light up when the device is
switched on.
Battery power (green LEDs):
Reserve ≤ 30% ≤ 60%
Temperature protection / low voltage
cutoff:
7
.
.
100%
26
7.1.2 Battery operating time
The service life of the battery mainly
depends on the load applied to the
device. Any cleaning work performed by
applying the brush with high pressure on
the surface to be cleaned will shorten the
service life of the battery. Another factor is
overly frequent starting and stopping
during cleaning, which can also reduce
battery operating time.
Handle battery and device as described in
the instructions.

7.2 User information


Do not remove any wet weeds with the
device.

Never clean wood decks or wood
terraces with the joint brush.

Only clean joints that are intact.
Damaged or crumbling joints or joints
with cracks should not be cleaned with
the device.

Rinse the cleaned surfaces thoroughly
after cleaning.

Worn brushes i.e. frayed wire bristles
should be replaced in good time.
To prevent damaging the device, it is
essential that the joint brush is replaced
when the diameter is < 90 mm.

7.3 Replacing the joint brush

Figures 10 - 14
CAUTION
RISK OF INJURY ON SHARP-EDGED OR
POINTED DEVICE PARTS!
During assembly or conversion work,
you may injure yourself on the joint
brush's worn wires.
It is therefore important to observe the
following safety instructions:
Wear protective gloves during assem-
bly!

Switch off the device and remove the
battery (C).
10
Remove the safety guard (L) by using
e.g. an Allen key (included in the