Pump Grip; Quick Closure Valve/Hose/Spraying Lance; Starting Up; Filling The Device - Gloria Hobby 1200 Mode D'emploi

5.2 Pump grip

Figure 9
The device types Pro 1300/1800 are equipped with an ergonomic handle which must be
mounted appropriately for left or right-hand use.
Mount the handle facing the left or right-hand side on the pump lever. Insert the handle
9
sections on the pump lever as shown.
NOTE!
You can choose between 2 insert positions which will shorten or extend the lever arm
of the pump lever according to the mounted handle position.
Insert the holding clip for the spraying lance as shown.
Then attach the second handle section and screw both handle sections to the pump lever as
shown.

5.3 Quick closure valve/hose/spraying lance

Figures 10 - 11
Push the hose up to the stop on the connection sleeve of the pump housing and screw
10
down tight with the coupling nut.
Push the hose up to the stop on the connection sleeve of the quick closure valve and
11
screw down with the coupling nut. Screw the spraying lance onto the quick closure valve.
Mount an extension if required (except type Hobby 1200).
6

Starting up

6.1 Filling the device

Figures 12 - 13
Remove the container cap and fill the device through the filling strainer. Close the
12
13
container with the container cap.
CAUTION
Note maximum fill level (see technical data), safety instructions and permissible
materials.
Check fill quantity.
Comply with the data of the spray product manufacturer!

6.2 Correctly fitting the shoulder strap / carrier system to the body

Figures 14 - 23
You can adjust your shoulder strap/carrier system (type-dependent) accurately to ensure
optimal load distribution and fatigue-free working. The device must be worn as close to the
body as possible and parallel to the spine.
Type Hobby 1200/1800: Padded shoulder strap
Fasten the shoulder straps as shown to the lower left and right outer strap buttons and
14
position the device on your back.
22