LIGHTING INSTRUCTIONS
WARNING: DO NOT lean over grill when lighting.
Turn off Gas supply when appliance is not in use.
DO NOT stand with head, body, or arms over the grill when lighting
1. Check the control knobs are all in the OFF
position.
2. Open LP cylinder valve.
3. Open lid before lighting.
4. Push and turn the knob slowly to HIGH. The burner
should ignite within three attempts.
5. If burner does not ignite, turn the knob to OFF, wait 5
minutes and then repeat step 4.
6. Once burner is lit, rotate knob to desired heating level
from High to Low
7. If the ignitor does not work, follow Match Lighting
instructions.
8. To turn off, turn the knob to HIGH first, then push in and turn to OFF position. Turn off the
gas tank valve before disconnecting the LP gas tank.
MATCH LIGHTING
1. Open lid before lighting
2. Place a match in the end of Match
Holder (hanging on the Right Front
Leg). Strike the match and place it
near side of the burner (see Fig.6)
3. Push and turn the control knob to
HIGH. The burner should ignite.
NOTE: If the burner does not ignite within the first few attempts of match lighting, there is a
problem with the gas supply. Turn off the gas at the burner and tank. DO NOT attempt to operate
the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual
or call the customer service department at CHANT-US (1-800-963-0211) from 8:00am to 5:00pm
Eastern time, Monday through Friday for assistance.
21
Fig.6