Master Forge BG2824BP-L Mode D'emploi page 25

CARE AND MAINTENANCE
Cleaning Main Burner
To prevent Flash backs and good performance of burner, the procedure below should be
followed at least once a month in late summer or early fall when spiders are most active
or when your grill has not been used for a period of time:
1. Turn off at control knobs and LP cylinder
2. Remove cooking grates and flame tamers
3. Remove hinge clip pins from rear of burners.
Detach ignition wire from the ignition pin by hand
only.
DO NOT use tool. Then Lift burner slowly.
4. Check all burner ports are clear of clogs. Use of a
pin or paper clip works well.
5. Ensure the end of the burner and primary air
screen are clear from insect nests, dirt or debris.
Using a bent stiff wire in the shape of a hook , or a
bottle brush, run it through the burner tube and
inside several times to remove any debris.
6. Inspect each burner for damage (cracks or holes)
and if such damage is found, order and install a
new burner.
Re-Installing Main Burners
Ensure the gas valve orifices must be correctly positioned inside the burner tube. If the burner
tube does not fit over the valve orifice, lighting the burner may cause explosion and/or fire.
It is recommended using a flashlight to view the correct position through the firebox vent holes
as illustrated below.
After checking, reattach each burner with the hinge clip pins and reattach the ignition wire to the
ignition pin by hand.
View the correct
position from the
bottom of the
firebox
Wrong
Wrong
25
Correct